1.Inspect your roof gutters. Your gutters shows the first signs of having roof replaced, especially when you see shingle granules inside your gutters. We spoke with Allen, with Gutter Cleaning Denver, and he said that "Keeping your gutters clean helps extends the life of roofs thus saving your money in the long run." · 2.Be sure to inspect the roof cover · 3.Inspect any skylight, it may need to be replaced · 4.During the time of re-roofing, most skylights may need to be replaced. You can expect a lifespan of 18 to 22 years for an individual skylight, so if the contractor's recommendation is the opposite of this general rule, be sure to ask them about it. One of the easiest ways to check the quality of the roof installation is to observe how the shingles have been aligned. Check if the cutouts of the three-tab shingles are vertical and if the butt joints are in the same horizontal plane.
Whether you are a roofing contractor or a homeowner who is going to have your roof replaced by a contractor. There are 32 things you can check during the 4 steps of the roofing process that will ensure that you or the homeowner have a quality roof replacement experience. There are numerous warning signs that could indicate improper roof repair work, ranging from improper cladding to improper shingle installation. So how can you tell if your roofing contractor did a great job? Here are a few things to look for in quality roofing work.
Before the roof can be repaired or installed, a specialized contractor will take the time necessary to repair the roof coating. Over time, the coating is likely to loosen due to a lack of nails or a lack of nails in an entire section of the coating. When the coating is not properly nailed, unsightly buckles may form on the roof over time due to deformation. When the coating is loose, the nails can come out, creating holes that cause the shingles to break or peel off.
Nail holes can also cause leaks. When looking for signs of quality roofing work, look for a contractor who has taken the time to repair the inadequate coating before continuing with the roof repair or installation. Good self-respecting roofers will always nail the shingles correctly and prevent excessive overhanging. When properly installed, the edges of the shingles hang about 1 ½ inch above the ceiling, or about ½ ¾, so that the edges drip off.
If you have excess, the shingles can come off in too much wind. If you don't have enough, water can drip onto rake or fascia boards. Do you notice that some of your shingles lift, slide, or just hang crooked? Then there's a big chance that your roof has been installed poorly and needs an inspection. A visibility check is performed to determine the quality of the roofing material.
This can be done a couple of weeks after the roof is finished, as long as there hasn't been a major storm between the construction of the roof and the time it was inspected.
Leave Reply